1. Safety Precautions:
- Park the car on a level surface, apply the parking brake, and turn off the engine.
- Disconnect the negative terminal of the battery to avoid any electrical accidents.
2. Locate the Gear Selector Cable:
- The gear selector cable is usually located under the car, near the transmission area.
3. Remove the Old Cable:
- Follow the cable from the gear selector lever to the transmission.
- Disconnect any attachments or brackets holding the cable in place.
- Loosen the jam nuts and disconnect the cable from both the gear selector lever and the transmission.
4. Replace the Cable:
- Begin by connecting one end of the new cable to the gear selector lever.
- If applicable, insert the cable through the cable guide.
- Connect the other end of the cable to the transmission and secure it by tightening the jam nuts.
- Ensure the cable is properly routed and seated in the guide.
5. Adjust the Cable Tension:
- With the gearshift in the neutral position, hold the cable at the transmission and move the selector lever.
- Adjust the barrel adjuster (near the transmission end of the cable) until the gearshift feels firm and there is slight resistance.
6.Reconnect the Battery:
- Reconnect the negative terminal of the battery.
7. Test the Cable:
- Check if the gearshift moves smoothly and engages the correct gears.
- Ensure the movement of the gear lever is smooth and there is no resistance in shifting.
Note:
- Be aware that some Protege models may differ slightly from this general guide. Consult the vehicle-specific service manual or seek assistance from a qualified mechanic if needed.
