- Jack and jack stands
- Lug wrench
- Socket wrench
- ratchet
- flathead screwdriver
- Brake grease
Instructions
1.) Park your car in a safe location and turn off the engine. Engage the parking brake.
2.) Loosen the lug nuts on the wheel that corresponds to the brake pad you are replacing. Do not remove the lug nuts completely.
3.) Jack up the car and place it on jack stands. Make sure the car is securely in place before proceeding.
4.) Finish removing the lug nuts and take off the wheel.
5.) Locate the brake caliper. It is the metal housing that contains the brake pads.
6.) Use a flathead screwdriver to pry the brake caliper off of the brake rotor. Be careful not to damage the rotor.
7.) Remove the old brake pads from the caliper. They are held in place by a metal clip.
8.) Clean the caliper and the brake rotor with a wire brush. Remove any dirt or debris that may be present.
9.) Apply a thin coat of brake grease to the back of the new brake pads. This will help to prevent them from squeaking.
10.) Install the new brake pads into the caliper. Make sure they are seated properly.
11.) Reinstall the brake caliper. Be sure to tighten the bolts securely.
12.) Replace the wheel and lug nuts. Do not tighten the lug nuts completely yet.
13.) Jack down the vehicle until it is touching the ground, then tighten the lug nuts. Be sure to tighten the lug nuts in a star pattern to ensure even pressure.
14.) Rest the car and test the brakes. Make sure they are working properly before driving.
