Tools and Materials Needed:
- Replacement sun visor clip (OEM part number: 91561-S01-003ZA)
- Small flat-head screwdriver or trim removal tool
- Phillips-head screwdriver
Instructions:
1. Locate the Sun Visor Clip:
- Open the sun visor and fully extend it towards the windshield.
- Look at the base of the sun visor where it attaches to the headliner. You'll see a small plastic clip holding the visor in place.
2. Remove the Old Clip:
- Use a small flat-head screwdriver or trim removal tool to pry open the clip. Be careful not to damage the headliner.
- Once the clip is open, use the Phillips-head screwdriver to remove the screw that holds the clip in place.
- Take out the old clip.
3. Install the New Clip:
- Align the new clip with the holes in the sun visor and the headliner.
- Insert the screw and tighten it with the Phillips-head screwdriver until the clip is securely fastened.
- Close the clip by pressing down on it until it snaps into place.
4. Test the Sun Visor:
- Open and close the sun visor to make sure that it's securely held in place by the new clip.
That's it! You've successfully replaced the sun visor clip in your 2003 Honda Accord. Now, you can enjoy a properly functioning sun visor that stays in place as you adjust it.
