Tools needed:
• Socket set
• Phillips-head screwdriver
• Pry bar
• Safety glasses
• Flashlight
1. Disconnect the Battery:
Disconnect the negative (–) battery terminal to de-energize the vehicle and prevent any electrical accidents.
2. Remove the Air Filter Box:
• Open the hood and locate the air filter box on the passenger side.
• Remove the lid by unscrewing the bolts and lifting it off.
3. Locate the Starter:
• The starter is located at the rear of the engine, near the transmission.
4. Disconnect the Electrical Connections:
• There are two main electrical connections on the starter: the solenoid terminal (usually larger) and the positive terminal (usually smaller).
• Disconnect these connections using a wrench or pliers.
5. Remove the Starter:
• Remove the starter mounting bolts using the appropriate size socket.
• Be careful not to drop the bolts.
6. Remove the Starter:
• Once the bolts are loosened, you can remove the starter by gently prying it away from the engine block using a pry bar or a large screwdriver.
7. Inspect the Starter:
• Inspect the starter for signs of wear, damage, or corrosion.
• Check for worn-out teeth on the starter gear as well.
8. Install the New Starter:
• Position the new starter in place.
• Install and finger-tighten the mounting bolts.
9. Reconnect Electrical Connections:
• Reattach the positive and solenoid terminals to the new starter.
10. Secure the Starter:
• Tighten the starter mounting bolts using the socket set.
11. Reinstall the Air Filter Box:
• Place the air filter box cover back in its place.
• Tighten the retaining bolts to secure it.
12. Reconnect the Battery:
• Reconnect the negative (–) battery terminal to the battery.
13. Test the Starter:
• Start the vehicle to ensure the starter is working properly.
Remember to take safety precautions by wearing protective eyewear and gloves when working around the car’s engine and electrical components. If you are not confident in performing these steps, it’s best to have the starter replaced by a qualified mechanic.
