* Lug wrench
* Socket wrench
* 17mm socket
* New lug stud
* Thread locker
Instructions
1. Park your car on a level surface and apply the parking brake.
2. Loosen the lug nuts on the wheel that you will be working on.
3. Jack up the car until the tire is off the ground.
4. Remove the lug nuts and take off the wheel.
5. Locate the lug stud that you will be replacing.
6. Use the 17mm socket to remove the lug nut that holds the stud in place.
7. Remove the stud by pulling it straight out of the hub.
8. Apply thread locker to the new stud.
9. Screw the new stud into the hub until it is snug.
10. Replace the lug nut and tighten it until it is snug.
11. Lower the car and replace the wheel.
12. Tighten the lug nuts in a star pattern until they are snug.
Test the lug nut to make sure it is tight. It should not move.
