Tools
- Jack and jack stands
- Lug wrench
- Safety glasses
- Flathead screwdriver
- Socket set
- Brake caliper press
Materials
- New brake pads (Make sure they are the correct size for your vehicle.)
- Brake grease
- Caliper guide pin grease
- Brake fluid
- DOT 3 or 4 brake fluid
Instructions:
1. Park your car on a level surface. Apply parking brake and chock the wheels.
2. Lift the rear of your car and support it on jack stands.
3. Remove the lug nuts and take off the wheels.
4. Locate the brake calipers on the rear wheels. They are the large metal components that house the brake pads.
5. Use the flathead screwdriver to pry open the metal clips holding the brake pads in place.
6. Now remove the old pads by pulling them straight out of the calipers.
7. Clean the caliper housing with a brush to remove any dust or debris.
8. Apply a small amount of brake grease to the back of the new brake pads. This will help to reduce noise and prevent them from sticking.
9. Insert the new brake pads into the calipers, making sure that they are seated properly.
10. Replace the metal clips to secure the brake pads in place.
11. Replace the wheels and lug nuts. Lower the car carefully.
12. Press on the brake pedal several times to seat the new brake pads.
13. Check the brake fluid level in the master cylinder and top it off if necessary.
14. Test the brakes to make sure they are working properly.
It is very important to inspect your brake pads regularly and replace them when they become too worn. Worn brake pads can cause your brakes to become less effective, which can increase your risk of an accident. Always refer to your car’s repair manual for specific instructions and guidance.
