1. Gather the Necessary Materials:
- Replacement Headlight (Same type as the original)
- Philips Head Screwdriver
- Socket Wrench (10 mm)
- Flat Head Screwdriver
- New Bulb (if replacing the bulb only)
2. Open the Hood:
- Pull the release lever inside the vehicle to release the hood.
- Locate the secondary release inside the engine and open the hood completely.
3. Locate the Headlight Assembly:
- The headlight assembly is situated within the front of the vehicle.
4. Remove the Bolts:
- Use the Philips head screwdriver to remove the bolts attaching the headlight assembly to the vehicle.
5. Detach the Electrical Connectors:
- Disconnect the electrical connectors located at the rear of the headlight assembly by gently pulling them apart.
6. Remove the Headlight:
- After removing the bolts and detaching the electrical connectors, you can gently lift and remove the headlight assembly from its place.
7. Replacing the Bulb:
- If you are only replacing the bulb, twist the old bulb counterclockwise and pull it out. Insert the new bulb and twist clockwise to secure it.
- In case you're replacing the entire assembly, this is where you would install the new headlight assembly.
8. Reattach the Electrical Connectors:
- Reconnect the electrical connectors for the new headlight assembly.
9. Secure the Headlight:
- Carefully place the headlight assembly in its original position and reattach the bolts using the Philips head screwdriver.
10. Close the Hood:
- Once everything is in place, close the hood and secure the latches.
Congratulations, you have successfully replaced the headlight on your Mazda Bongo. Always be cautious when working around electrical components, and refer to your vehicle's owner's manual for specific guidelines for your model.
