1. Park your car on a level surface and turn off the engine.
* Engage the parking brake.
2. Open the hood of your car.
3. Locate the windshield washer tank.
* The windshield washer tank is a plastic container located on the passenger side of the engine compartment, near the firewall.
4. Disconnect the electrical connector from the windshield washer pump.
* The electrical connector is a small, plastic plug that connects the pump to the wiring harness.
5. Disconnect the windshield washer hose from the pump.
* The windshield washer hose is a small, rubber hose that connects the pump to the windshield washer nozzles.
6. Remove the two bolts that hold the windshield washer tank in place.
* The bolts are located on the bottom of the tank.
7. Lift the windshield washer tank out of the engine compartment.
* Be careful not to spill any washer fluid.
8. Install the new windshield washer tank.
* Position the new tank in the engine compartment and insert the two bolts.
* Tighten the bolts until they are snug.
9. Connect the windshield washer hose to the pump.
* Make sure that the hose is securely connected.
10. Connect the electrical connector to the pump.
* Make sure that the connector is securely plugged in.
11. Add windshield washer fluid to the tank.
* Fill the tank to the "Full" mark.
12. Close the hood of your car and you're done!
