How do I replace a cracked primer bulb of Eager Beaver 2014 chainsaw?

Tools and Materials Needed:

- Replacement primer bulb (check the user manual for the specific model number or size of the primer bulb required)

- Screwdriver

- Pliers or tweezers (optional)

Instructions:

1. Safety First: Ensure that the chainsaw is powered off and disconnected from any power source. Allow it to cool down if it has recently been in use.
2. Locate the Primer Bulb: The primer bulb is typically a small, round, rubber bulb located near the carburetor on the chainsaw. It is responsible for drawing fuel into the carburetor.
3. Remove the Old Primer Bulb: Use a screwdriver or pliers (if necessary) to gently pry off the cracked primer bulb from its housing. Be careful not to damage the surrounding parts.
4. Clean the Housing: Once the old primer bulb is removed, take a moment to clean the housing area to remove any dirt, debris, or old fuel residue. This will help ensure a good seal for the new primer bulb.
5. Install the New Primer Bulb: Align the new primer bulb with the housing and gently press it into place. Ensure that it is securely seated and forms a tight seal.
6. Reconnect Any Components: If you had to disconnect any parts during the process, such as fuel lines, reconnect them now.
7. Test the Primer Bulb: Press the new primer bulb several times to ensure that the fuel is drawn up properly. You should feel resistance when pressing it and see fuel flowing through the fuel line.
8. Start the Chainsaw: Once you have verified that the primer bulb is functioning correctly, you can start the chainsaw as per the user manual.

Remember to follow the specific instructions provided in the user manual for your particular Eager Beaver 2014 chainsaw model. If you encounter any difficulties, consult the user manual or seek assistance from a qualified professional or an authorized service center.