Auto >> AutoSPT >  >> Auto Repair

Reset the check engine light 2003 jaguar x-type?

To reset the check engine light on a 2003 Jaguar X-Type, you can follow these steps:

1. Turn the ignition key to the "On" position, but do not start the engine.

2. Locate the diagnostic trouble code (DTC) reader port in your vehicle. In the 2003 Jaguar X-Type, it is usually located under the dashboard, on the driver's side.

3. Connect the DTC reader to the port. The DTC reader is a device used to read and erase trouble codes from the vehicle's on-board computer.

4. Turn the ignition key to the "Off" position.

5. Wait for a few seconds, then turn the ignition key to the "On" position again.

6. The DTC reader will display the trouble codes that are stored in the vehicle's computer.

7. Use the DTC reader to erase the trouble codes. This should reset the check engine light.

If the check engine light does not reset, you may need to have the vehicle diagnosed by a professional to determine the cause of the issue.

Auto Repair
How do you change the starter on a 1999 Ford F150? How do you remove rear wheel bearings on a Chevy Cavalier?
Car Care
Synthetic Oil vs Regular Oil How dependable are Chevy trucks? What Does a Car’s Alternator Do?
Engine
Why is Engine light on 2005 Envoy? What engine mods do you need to perform on your Yamaha G1 2 stroke engine?
Electric Car
How long does it take to drive from Lincoln NE Atlanta Georgia? 2004 Chevy Tahoe not blowing air from AC fuse good. thanks? Can you put a 1985 corvette tail lights on 1992 zr1 will it directly fit on?
Autopilot
Who is Developing Driverless Cars? Is there flywheel in two wheeler bike?
Car Photos
Besides bent rims and or bad tires what else can cause serious car shaking at high speeds? What do the dashboard symbols on a dodge sprinter van mean? What parts from another car interchange with a 1990 Honda CRX?