1. Park your car in a safe location and apply the parking brake.
2. Locate the emergency brake cable under the car. It is a metal cable that runs from the brake pedal to the rear brakes.
3. Inspect the cable for damage. Look for any signs of fraying, kinking, or rust. If the cable is damaged, it will need to be replaced.
4. If the cable is not damaged, you may need to adjust it. To do this, locate the adjustment nut on the cable near the rear brakes. Turn the nut clockwise to tighten the cable and counterclockwise to loosen it.
5. Test the emergency brake. Pull up on the brake pedal and make sure that it engages firmly. The car should not roll when the emergency brake is engaged.
6. If the emergency brake is still not working properly, you may need to have it repaired by a qualified mechanic.
Here are some additional tips for repairing the emergency brake in a 1994 Probe GT:
* If the cable is frayed, you can try to splice it together with a piece of electrical tape. However, this is only a temporary solution. The cable should be replaced as soon as possible.
* If the cable is kinked, you can try to straighten it out with your hands. However, be careful not to damage the cable. If you cannot straighten the cable, it will need to be replaced.
* If the cable is rusty, you can try to clean it with a wire brush. However, if the rust is severe, the cable will need to be replaced.
