- 10mm wrench
- 12mm wrench
- 14mm wrench
- Ratchet
- Socket set (10mm and 14mm sockets)
- New alternator belt (check owner's manual for correct size)
Instructions:
1. Open the hood of the vehicle and locate the alternator. The alternator is typically mounted on the front of the engine, near the top.
2. Loosen the 14mm bolt that holds the alternator in place. Do not remove the bolt completely.
3. Slide the 10mm wrench between the alternator and the tensioner pulley. This will help to loosen the tension on the alternator belt.
4. Use the 12mm wrench to turn the tensioner pulley clockwise. This will release the tension on the alternator belt.
5. Remove the old alternator belt from the alternator and the tensioner pulley.
6. Install the new alternator belt by wrapping it around the alternator and the tensioner pulley.
7. Turn the tensioner pulley clockwise until the new alternator belt is tight.
8. Tighten the 14mm bolt that holds the alternator in place.
9. Close the hood of the vehicle.
Tips:
- If the alternator is difficult to reach, you may need to remove the air intake hose or other components to access it.
- Be careful not to over-tighten the alternator belt. This could damage the alternator or the belt.
- If the new alternator belt squeals or chirps, it is too loose. Tighten the belt until the noise goes away.
