Bypassing a vehicle immobilizer is a complex and potentially illegal task. It should only be attempted by experienced professionals. If you are not qualified, it is strongly recommended that you consult a qualified automotive technician for assistance.
_Here is a general overview of how to bypass a VS Commodore immobilizer._
1. Locate the immobilizer control unit. In the VS Commodore, it is usually a small black box with a red wire that connects to the ignition.
2. Disconnect the red wire from the immobilizer control unit.
3. Turn on the ignition. The engine should start now.
4. If you want the immobilizer to continue to work but can't locate the problem connect a 470-ohm, 1/4-watt resistor in line between the cut red immobilizer wire and the main ignition harness connector (where the original immobilizer wire was).
Here are some additional tips:
- Be careful not to damage any wires during the process.
- If you’re not confident doing electrical work, it is best to leave it to a qualified professional.
- Reattach the red wire before starting the engine again.
