1. Park your truck on a level surface and turn off the engine.
2. Pop the hood and locate the clutch master cylinder. It is located on the firewall near the top of the engine.
3. Remove the cap from the clutch master cylinder.
4. Use a turkey baster or syringe to remove as much fluid from the master cylinder as possible.
5. Once the master cylinder is empty, loosen the bleeder screw on the slave cylinder. The slave cylinder is located on the transmission bell housing.
6. Have a helper slowly press down on the clutch pedal while you watch the fluid coming out of the bleeder screw. Continue bleeding the system until clean, clear fluid comes out of the bleeder screw. If you find any air in the system, keep bleeding until it is completely purged.
7. Once the system is bled, close the bleeder screw and fill the master cylinder with fresh clutch fluid.
8. Replace the cap on the master cylinder and test the clutch pedal to make sure it feels firm and engages smoothly.
