Auto >> AutoSPT >  >> Auto Repair

How do you remove and replace OD switch on floor shift lever 97 Taurus?

To remove and replace the OD switch on a 1997 Taurus with a floor shift lever, follow these steps:

1. Park your car on a flat surface and turn off the engine. Engage the parking brake.

2. Lift the center console lid to access the shift lever.

3. Locate the OD switch, which is located on the side of the shift lever. It is usually a black or gray button.

4. Disconnect the electrical connector attached to the OD switch.

5. Press down on the tab on the side of the switch and pull it out of the housing.

6. To install the new OD switch, simply insert it into the housing and press until it clicks into place.

7. Reconnect the electrical connector and close the center console lid.

8. Start the engine and test the OD switch to make sure it is working properly.

Note: If the OD switch is still not working properly after you have replaced it, you may need to replace the shift lever assembly.

Auto Repair
How do you replace the driver side sun visor on a 2001 Chevy Malibu? Toyota Recalls Prius, Lexus Hybrid For Faulty Brakes
Car Care
What to Do When Power Steering Goes Out Signs of a Bad EGR Valve: Your Ultimate Guide! The Camouflaged Cannonball Record Car (Cannonball History Part 3)
Engine
Your 92 lesabre will crank and run with your foot on the gas if you let off it stalls have replaced fuel filter tps please help me? Where is the drain plug located on transmission for a 2005 Chrysler sebring 2.7 v6 engine?
Electric Car
Where is the rear brake switch for a 1992 Chevy G20 Conversion Van? What to do when the check charging system light go off on a 2000 Ford Windstar SEL? What strategy did Henry Ford implement to produce more automobiles?
Autopilot
How do you spot a fake armani watch? To Share or Not to Share?
Car Photos
What is the stereo wiring diagram 1999 Mazda Protege? How do you get the vin number for a vehicle using license plate? What type of materials are car tires made from?