Materials Needed:
- Replacement brake rotors (2)
- Brake pads
- Caliper bolts
- Brake grease
- C-clamp or brake caliper tool
- Socket wrench set
- Tire iron
- Jack
- Jack stands
Instructions:
1. Safety First:
- Engage the parking brake and chock the wheels to prevent the vehicle from rolling.
2. Remove the Tires:
- Loosen the lug nuts on the wheel covering the brake rotor you want to replace.
- Use a jack and jack stands to raise the vehicle and safely remove the tire.
3. Remove the Caliper:
- Locate the caliper bolts on the back of the caliper bracket.
- Use a socket wrench to loosen and remove the caliper bolts.
- Gently slide the caliper off the rotor, taking care not to damage the brake line or caliper piston.
4. Remove the Old Rotor:
- There may be one or two retaining screws securing the rotor to the hub. Remove them.
- Remove the old rotor by gently tapping it with a hammer and pulling it off the hub.
5. Clean the Hub:
- Use a wire brush to clean the hub and remove any rust or debris.
6. Apply Brake Grease:
- Apply a thin coat of brake grease to the hub to help the new rotor slide smoothly.
7. Install the New Rotor:
- Place the new rotor on the hub and ensure that it seats properly.
- Reinstall the retaining screws, if any.
8. Reattach the Caliper:
- Slide the caliper back onto the rotor, aligning the caliper bolts with the holes.
- Reinstall and tighten the caliper bolts securely.
9. Install Brake Pads (if needed):
- If you are replacing the brake pads along with the rotors, now is the time to install them.
10. Test the Brakes:
- Once everything is reinstalled and secured, reinstall the tire.
- Lower the vehicle and remove the jack stands.
- Perform a test drive to check if the brakes are functioning correctly.
Note: This guide is general in nature, and the steps may vary slightly for your specific vehicle model. Always refer to the manufacturer's service manual or consult a professional mechanic if you are not confident in performing the task.
