* Screwdriver
* Pliers
* Adjustable wrench
* Socket set
* Rags
* Drain bucket
Parts
* New direct drive coupling
Instructions
1. Unplug the washer from the power outlet and turn off the water supply.
2. Remove the back panel of the washer by removing the screws that hold it in place.
3. Locate the direct drive coupling, which is located at the bottom of the wash tub.
4. Remove the bolts that hold the direct drive coupling in place and remove the old direct drive coupling.
5. Clean the area around the direct drive coupling and inspect it for any damage. If there is any damage, you will need to replace the wash tub.
6. Install the new direct drive coupling by inserting it into the wash tub and securing it with the bolts you removed earlier.
7. Replace the back panel of the washer and plug in the washer.
8. Turn on the water supply and run the washer through a spin cycle to test the repair.
Tips
* When removing the old direct drive coupling, be careful not to lose the small springs that are located between the coupling and the wash tub.
* If you have any difficulty removing the old direct drive coupling, you may need to use a penetrating oil to loosen the bolts.
* Be sure to clean the area around the direct drive coupling before installing the new one. This will help to ensure a good seal and prevent leaks.
