- Replacement washer pump
- Socket wrench
- Pliers
- Screwdriver
- Container to drain the washer fluid
Instructions:
1. Locate the washer pump. It's usually located in the engine compartment, near the washer fluid reservoir.
2. Disconnect the electrical connector to the washer pump.
3. Disconnect the washer fluid hose from the pump. Use pliers to loosen the hose clamp and then pull the hose off.
4. Remove the mounting bolts that hold the pump in place. Use a socket wrench to loosen the bolts.
5. Pull the pump out of its housing. Be careful not to spill any washer fluid.
6. Install the new washer pump. Insert the new pump into the housing and secure it with the mounting bolts.
7. Reconnect the washer fluid hose to the pump.
8. Reconnect the electrical connector to the pump.
9. Test the washer pump. Turn on the windshield wipers and make sure the washer fluid sprays out of the nozzles.
10. Reinstall any covers or panels that you removed.
Tips:
- Before you begin, make sure the ignition is turned off and allow the engine to cool down.
- Wear safety goggles to protect your eyes from washer fluid.
- If you spill any washer fluid, clean it up immediately to avoid staining the paint.
