- Replacement turn signal indicator
- Philips screwdriver
- Flat-head screwdriver
- Wire cutters
- Wire strippers
- Electrical tape
Step 2: Remove the old turn signal indicator.
1. Locate the turn signal indicator that you need to replace.
2. Use the flat-head screwdriver to pry the indicator housing open.
3. Use the Philips screwdriver to remove the two screws securing the indicator to the housing.
4. Disconnect the electrical connector by pressing down on the release tab and pulling it apart.
5. Remove the indicator from the housing.
Step 3: Install the new turn signal indicator.
1. Place the new indicator in the housing.
2. Secure the indicator with the two screws.
3. Reconnect the electrical connector.
4. Snap the indicator housing closed.
Step 4: Test the turn signal indicator.
1. Turn on the turn signal switch.
2. Check that the indicator lights up correctly.
Step 5: Clean up.
1. Discard the old turn signal indicator and any other trash.
