Auto >> AutoSPT >  >> Electric car

How do you pull down the back seat of a 2008 Chevy Cobalt?

The 2008 Chevy Cobalt has a split-folding rear seat. To fold it down, you typically need to do the following:

1. Locate the release levers: These are usually located on either side of the rear seat, either at the top of the seatback itself or on the side of the seatback near the bottom. They may be pull straps, levers, or buttons. Check your owner's manual for the exact location. Some models might have them hidden in the trunk if there is no access from the cabin.

2. Pull the levers: Pull the release lever(s) firmly. This will unlock the seatback latch.

3. Fold the seatback down: Push the seatback forward until it folds down flat against the seat cushion.

Important Note: The exact location and mechanism of the release levers can vary slightly depending on the trim level of your 2008 Chevy Cobalt (LS, LT, SS, etc.). Your owner's manual is the best resource for precise instructions and diagrams. If you can't find the levers, consulting your owner's manual will be vital.

Auto Repair
How do you repair brake lines on a 1994 Acura Integra? How do you change the lower control arm on a Nissan Xterra?
Car Care
where to buy the handicap vans? Junk Cars For Cash Phoenix – Who Buys Junk Cars In Phoenix Arizona? How To Replace Car Door Locks: The Step-By-Step Guide
Engine
Where is the drain plug on a nv5600 transmission for 2001 dodge 3500 Cummins diesel? Cam timing mark on vw 2.5 tdi transporter acv engine?
Electric Car
What causes the transmission to automatically downshift and stick in a lower gear 1995 Chrysler cirrus? Where is the thermostat located on a 1990 Buick Century 3300 V6? Why does my car idle rough when parked or picking up speed driving slowly?
Autopilot
How to Adjust clutch pedal height peugeot 307? How do you spot a fake armani watch?
Car Photos
Where to find parts for a leipai ATV? Where is the oil filter on a 2007 Honda crv? What are the rear and front tire sizes for a Honda 200s 1985 3 wheeler?