- Phillips head screwdriver
- Flathead screwdriver
- New mirror assembly
- 10mm socket wrench
- 7mm socket wrench
- Electrical tape
Instructions:
1. Remove the door panel:
- Begin by prying off the plastic cover located in the center of the door panel.
- Using a Phillips head screwdriver, remove the screws holding the door panel in place (one screw is located behind the plastic cover).
- Pry the door panel off, starting from the bottom, and then lift it upwards to remove it.
2. Disconnect the electrical connector:
- Locate the electrical connector for the power mirror, it's usually near the door lock mechanism.
- Squeeze the release tab to disconnect the electrical connector.
3. Remove the old mirror assembly:
- Locate the 10mm bolts that hold the mirror in place. Use the 10mm socket wrench to remove the bolts.
- Gently pull on the mirror assembly to detach it from the door.
4. Install the new mirror assembly:
- Hold the new mirror assembly in place and align it with the mounting holes.
- Insert the 10mm bolts and tighten them securely with the 10mm socket wrench.
5. Reconnect the electrical connector:
- Snap the electrical connector back into the power mirror until you hear a click.
6. Reinstall the door panel:
- Lift up the door panel, ensuring that all the clips are properly aligned with their respective holes.
- Replace the screws you removed earlier to secure the door panel.
- Snap the plastic cover back into place.
7. Test the mirror:
- Once everything is in place, test the power mirror by adjusting it from the inside controls to ensure it's working correctly.
*Remember, if you are uncomfortable performing this task, it's best to consult a professional mechanic for assistance.*
