* Phillips head screwdriver
* Flat head screwdriver
* Trim removal tool
* Speaker wire
* Electrical tape
* Wire cutters
* Crimpers
1. Remove the rear seat.
* Pull up on the front edge of the seat cushion to release the clips.
* Slide the seat cushion forward and remove it from the vehicle.
* Remove the two bolts that hold the seat back in place.
* Lift the seat back up and remove it from the vehicle.
2. Remove the rear speaker grilles.
* Use a trim removal tool to pry the grilles off of the door panels.
3. Remove the old speakers.
* Use a Phillips head screwdriver to remove the screws that hold the speakers in place.
* Disconnect the speaker wires.
4. Install the new speakers.
* Connect the speaker wires to the new speakers.
* Secure the speakers in place with the screws you removed earlier.
5. Reinstall the rear speaker grilles.
* Snap the grilles back into place on the door panels.
6. Reinstall the rear seat.
* Replace the seat back and secure it with the bolts you removed earlier.
* Slide the seat cushion back into place and secure it with the clips.
7. Test the speakers.
* Turn on the radio and make sure the rear speakers are working.
