- New thermostat (check your owner's manual for the correct part number)
- Socket set
- Ratchet
- Wrench
- Pliers
- Coolant (check your owner's manual for the correct type and amount)
- Funnel
- Rags
Instructions:
1. Park your car in a level area and turn off the engine. Allow it to cool down.
2. Open the hood of your car.
3. Locate the thermostat housing. It is usually located near the top of the engine, near the radiator hose.
4. Use the socket set and ratchet to loosen the bolts holding the thermostat housing in place.
5. Remove the bolts and carefully remove the thermostat housing.
6. Remove the old thermostat from the housing. Be careful not to spill any coolant.
7. Install the new thermostat in the housing, making sure it is properly seated.
8. Reinstall the thermostat housing and bolts, and tighten them snugly.
9. Use the funnel to add coolant to the radiator until the level reaches the "full" mark.
10. Replace the radiator cap.
11. Start the engine and let it run for a few minutes. Check for any leaks from the thermostat.
11. Turn off the engine and check the coolant level again. If necessary, add more coolant.
Note: If you have any questions or concerns, consult a professional mechanic.
