Auto >> AutoSPT >  >> Electric car

How do you bypass power window switch with a jumper wire to raise window?

To bypass the power window switch with a jumper wire to raise the window, follow these steps:

Step 1: Locate the window motor and switch. The window motor is usually located in the door panel, and the switch is usually located on the armrest or door panel.

Step 2: Disconnect the wiring harness from the switch. There is usually a small connector that holds the wiring harness to the switch. Use a flathead screwdriver to pry it open.

Step 3: Identify the power and ground wires. The power wire is usually red or orange, and the ground wire is usually black or brown.

Step 4: Connect the jumper wire to the power and ground wires. Use a piece of wire that is about 6 inches long. Strip the ends of the wire and twist them together. Connect one end of the wire to the power wire, and the other end of the wire to the ground wire.

Step 5: Test the window. Turn the key in the ignition to the "On" position. The window should now work correctly. Be sure to remove the jumper wire when you are finished.