Hotwiring a Baja 90cc ATV is a relatively simple process that can be done in a matter of minutes. However, it is important to note that this is a temporary fix and should only be used until you can obtain a replacement key.
To hotwire a Baja 90cc ATV, you will need the following tools:
* A screwdriver
* A pair of pliers
* A length of wire
Once you have gathered your tools, follow these steps:
1. Remove the ignition cover. This is typically held in place by a few screws.
2. Locate the ignition switch. It is usually a black or gray box with a wire attached to it.
3. Find the power wire. This is typically the red wire attached to the ignition switch.
4.Connect the power wire to the ground wire. This can be done by wrapping the wire around the ground wire and then twisting it together.
5. Test the connection. Turn the key to the "on" position and see if the engine starts. If it does, then you have successfully hotwired your ATV.
6. Disconnect the power wire from the ground wire. Once you are finished using the ATV, disconnect the power wire from the ground wire to prevent the battery from draining.
Note: Hotwiring an ATV can be dangerous and could cause damage to the vehicle's electrical system or starter. It is important to note that this should only be done as a last resort and that you should consult with a professional as soon as possible.
