* Philips head screwdriver
* Flathead screwdriver
* 10 mm socket wrench
* 13 mm socket wrench
* New blower motor
Instructions:
1. Disconnect the negative terminal of the battery.
2. Locate the blower motor resistor. It is usually located on the passenger side of the engine compartment, near the firewall.
3. Remove the two screws that hold the blower motor resistor in place.
4. Disconnect the electrical connector from the blower motor resistor.
5. Locate the blower motor. It is usually located on the passenger side of the car, under the dashboard.
6. Remove the four screws that hold the blower motor in place.
7. Disconnect the electrical connector from the blower motor.
8. Remove the blower motor from the car.
9. Inspect the blower motor for damage. If it is damaged, replace it with a new one.
10. Reverse the steps to install the new blower motor.
11. Reconnect the negative terminal of the battery.
12. Test the blower motor to make sure that it is working properly.
