- New injector
- Socket wrench set
- Flat-head screwdriver
- Pliers
- Rags
- Safety goggles
Procedure
1. Disconnect the battery. This is to prevent any electrical accidents from happening while you are working on the injectors.
2. Remove the engine cover. This is usually held in place by a few bolts or clips.
3. Locate the injectors. They are located on the top of the engine, near the spark plugs.
4. Disconnect the electrical connectors from the injectors. Use a flat-head screwdriver to release the clips that hold the connectors in place.
5. Remove the fuel lines from the injectors. Use pliers to loosen the clamps that hold the fuel lines in place.
6. Use a socket wrench to loosen and remove the bolts that hold the injectors in place.
7. Remove the injectors from the engine. Be careful not to drop them.
8. Inspect the injectors for damage. If any of them are damaged, they will need to be replaced.
9. Install the new injectors. Be sure to align the injector tips correctly with the fuel injector ports.
10. Tighten the bolts that hold the injectors in place.
11. Reattach the fuel lines to the injectors.
12. Reattach the electrical connectors to the injectors.
13. Reconnect the battery.
14. Start the engine and check for leaks. If there are any leaks, tighten the bolts or clamps that hold the injectors in place.
