- 10 mm socket
- T25 Torx bit
- Small flat-blade screwdriver
- Pliers
- Electrical tape
Instructions
1. Disconnect the battery.
2. Remove the front wheels.
3. Remove the plastic wheel well liners.
4. Locate the ABS control module. It is located in the engine bay or behind the battery in a plastic housing, or under the hood in front of the engine.
5. Disconnect the electrical connectors to the ABS control module.
6. Remove the bolts holding the ABS control module in place.
7. Remove the ABS control module.
8. Install the new ABS control module in the reverse order of removal, be sure to apply a thin coat of dielectric grease to the terminals of the new ABS module.
9. Reconnect the battery.
10. Test the ABS brakes by applying them while driving slowly in an empty parking lot. The ABS system should activate and prevent the wheels from locking up.
