- A jack and jack stands
- A set of wrenches
- A set of sockets
- A screwdriver
- A pry bar
- New shocks
- New shock mounts
- New shock bushings
Instructions:
1. Park the vehicle on a level surface.
2. Turn off the engine and allow it to cool down.
3. Engage the parking brake.
4. Raise the vehicle using the jack and jack stands. Make sure the vehicle is securely supported before proceeding.
5. Locate the air ride shocks. They are located at the front and rear of the vehicle.
6. Use the wrenches and sockets to remove the bolts that hold the shocks in place.
7. Remove the shocks from the vehicle.
8. Install the new shock mounts and bushings.
9. Install the new shocks.
10. Tighten the bolts that hold the shocks in place.
11. Lower the vehicle using the jack and jack stands.
12. Test the new shocks by driving the vehicle over bumps and uneven surfaces.
It is important to note that this procedure may vary depending on the specific make and model of the vehicle. If you are unsure about how to change the shocks, it is best to consult a professional mechanic.
