Auto >> AutoSPT >  >> Electric car

How do you turn off engine light after removing converter on 2000 Chevrolet metro?

To turn off the engine light after removing the converter on a 2000 Chevrolet Metro, you will need to reset the Engine Control Unit (ECU). Here are the steps to do so:

1. Disconnect the negative battery terminal: This will cut power to the ECU and clear any stored codes.

2. Wait for 15 minutes: This will allow the ECU to completely reset itself.

3. Reconnect the negative battery terminal: This will restore power to the ECU.

4. Start the engine: The engine light should now be off.

If the engine light remains on, you may need to have the ECU reprogrammed by a qualified mechanic.

Auto Repair
How do you tighten tie rod on 1998 Ford Taurus? How to remove rear brake cover dodge caravan 1997?
Car Care
Why cigarette lighter work in car? Is Your Car’s Alternator Going Bad? Caliper Piston Won’t Compress: Common Causes & Solutions
Engine
Where is the egr valve on a dodge shadow with 2.2 engine? Will a vw beetle engine work in bus?
Electric Car
Where is the torque converter on a 2001 Chevy Blazer? How do you replace the battery on a 1988 Corvette Convertible? How much does it cost to change the alternator in a car?
Autopilot
Driverless Vehicles: Who’s Paying? Do Driverless Vehicle Companies Need Permission to Operate on Public Roadways?
Car Photos
How do you reset a car stereo in Volvo when it says off? How do you turn on the fog lights a 1999 VW Beetle? Where is the VIN located on a 1967 Ford Thunderbird?