* Flat-head screwdriver
* Phillips-head screwdriver
* Ratchet
* 10mm socket
* Hammer
Instructions:
1. Park your vehicle on a level surface and apply the parking brake.
2. Place the gear selector in the "Park" position (automatic transmission) or the "Neutral" position (manual transmission).
3. Locate the rear brake cover. It is located on the back side of the rear wheel.
4. Remove the two Phillips-head screws that secure the rear brake cover to the vehicle.
5. Use a flat-head screwdriver to pry the rear brake cover off of the vehicle. Be careful not to damage the cover or the surrounding components.
6. Once the rear brake cover is removed, you will have access to the rear brake assembly.
Reinstallation:
1. To reinstall the rear brake cover, simply reverse the steps above.
2. Make sure that the brake cover is properly seated and secured before you drive your vehicle.
