Auto >> AutoSPT >  >> Electric car

Where is the IAT sensor on a 97 Honda Accord?

The IAT (intake air temperature) sensor on a 1997 Honda Accord is located in the air intake duct, just before the throttle body. It is a small, cylindrical sensor with two wires coming out of it. The sensor is held in place by a single bolt.

To remove the IAT sensor, you will need a screwdriver and a 10mm wrench.

1. Disconnect the negative battery terminal.

2. Locate the IAT sensor in the air intake duct.

3. Use the screwdriver to remove the screw that holds the sensor in place.

4. Disconnect the two wires from the sensor.

5. Remove the sensor from the air intake duct.

To install the new IAT sensor, simply reverse the steps above.

Be sure to tighten the screw that holds the sensor in place securely. If the screw is not tightened securely, the sensor may come loose and fall out. This could cause the engine to run rich, which can lead to decreased fuel economy and performance.

Auto Repair
AM/FM Radio Preferred Listening Option For Most Drivers Does Duramax Have Glow Plugs?
Car Care
Honda CRV Won’t Start: What’s Going on And How to Fix the Problem?  What is a Personal to Holder vehicle? 10 Foreign Cars You Didn’t Know Were Built in the U.S.
Engine
How do you start a Yamaha kt100 engine? What is the engine size in a 1996 Chrysler Sebring?
Electric Car
What vehicle dealerships sell electric motorcycles? How do you remove the air filter housing on a Mazda 626 lx v6 1998? Should a battery spark if you put the positive terminal before negative?
Autopilot
Is a 800cc motorcycle good for beginner rider? What is the picture indicator round with arrows pointing to middle on dashboard?
Car Photos
How much horsepower do modified cams give you? How do you remove taillight of a Mazda 3? How do they find the car?