1. Gather the necessary materials. You will need:
* 911EP Led Light bar
* Orion Elite controller
* 16 AWG wire (red, black, and white)
* Wire strippers
* Crimpers
* Heat shrink tubing
2. Prepare the wire. Cut the red, black, and white wire to the desired length. Strip the ends of the wire about 1/4 inch.
3. Connect the wires to the light bar. The red wire should be connected to the positive terminal on the light bar, the black wire should be connected to the negative terminal, and the white wire should be connected to the data terminal.
4. Connect the wires to the controller. The red wire should be connected to the +12V terminal on the controller, the black wire should be connected to the GND terminal, and the white wire should be connected to the Data terminal.
5. Test the lights. Turn on the power to the controller and test the lights. The lights should turn on and off when you press the buttons on the controller.
6. Secure the wires. Use heat shrink tubing to secure the wires. This will help to protect the wires from damage.
Here is a diagram of the wiring connections:
[Image of a wiring diagram]
Once the wires are connected, you can test the light bar by turning on the power to the controller. The light bar should light up. If it does not, check the wiring connections to make sure that they are correct.
