• A Phillips-head screwdriver
• A flat-head screwdriver
• A T20 Torx screwdriver
1. Disconnect the battery.
2. Remove the glove compartment.
3. Remove the three Phillips-head screws holding the blower motor in place.
4. Unplug the electrical connector from the blower motor.
5. Remove the blower motor from the vehicle.
Installation is the reverse of removal.
Here are some additional tips:
• Be careful not to drop any screws into the HVAC system.
• If the blower motor is stuck, you may need to use a pry bar to remove it.
• When reinstalling the blower motor, make sure that the electrical connector is properly seated.