4-wire oxygen sensor two white wires one blk gray which wire connects where 2000 jeep wranglerplug is diffreant square instead of round how can i tell to above color are?

1. Identify the wires:

- White wires: These are the O2 sensor heater wires.

- Black/gray wire: This is the O2 sensor ground wire.

- Remaining white wire: This is the O2 sensor signal wire.

2. Connect the wires:

- White wires: Connect these to the corresponding pins on the square plug labeled "heater" or "HTR."

- Black/gray wire: Connect this to the pin on the square plug labeled "ground" or "GND."

- Remaining white wire: Connect this to the pin on the square plug labeled "signal" or "SIG."

Additional notes:

- Double-check the wiring: Before starting the engine, make sure the wires are securely connected and that there are no loose ends.

- Consult a wiring diagram: If you're unsure about the wiring, consult a wiring diagram for your specific Jeep Wrangler.