To hot-wire a 2003 Dodge Durango, follow these steps:
Step 1: Open the driver's door and locate the ignition switch.
Step 2: Locate the three wires connected to the ignition switch.
- These wires are usually red, yellow, and white.
- The red wire is the power wire,
- the yellow wire is the starter wire, and
- the white wire is the ground wire.
Step 3: Strip the ends of the three wires using a wire stripper.
*Step 4:* Connect the red wire to the yellow wire. This will turn on the power in the car.
Step 5: Connect the white wire to the red wire.
- It will now bypass the ignition switch and start the car. Turn the key to see if the power came on.
- This could also turn on other electrical power, like the AC and audio equipment.
-If everything you turned on using the key powers ON when you touch the white and red lines together, they are properly connected.
Step 6: Remove the two wires you just connected as soon as your truck starts; otherwise, something in your vehicle could potentially fry from the extra flow of current. They've now hot-wired a 2003 Dodge Durango.
