* Master Cylinder: This is the heart of your braking system. It's a hydraulic pump that creates pressure when you press the brake pedal.
* Brake Lines: These are the tubes that carry the hydraulic fluid from the master cylinder to the calipers at each wheel.
* Calipers: These are the clamps that hold the brake pads against the rotors. When you press the brake pedal, hydraulic pressure pushes the calipers to squeeze the pads against the rotors, slowing or stopping the vehicle.
Specifically, the brake lines follow this general path:
1. From Master Cylinder: The brake lines originate at the master cylinder, typically with a splitter that creates two main lines.
2. To Front Wheels: One main line usually goes to the front axle, where it splits again to connect to each front caliper.
3. To Rear Wheels: The other main line usually goes to the rear axle, splitting again to connect to each rear caliper.
Important Note: The specific routing of brake lines can vary depending on the vehicle's make and model. Some vehicles might have different configurations, such as a single line running to a proportioning valve that then distributes fluid to the wheels.
If you have any doubts about your specific vehicle's brake line routing, consult your owner's manual or a mechanic for accurate information.
