Auto >> AutoSPT >  >> Engine

What is the fuel pump pressure on a 1987 s 10 with 2.5 engine?

The fuel pressure specification for a 1987 S-10 with a 2.5L engine is 9-13 psi. This should be measured at the fuel rail with the engine running. Keep in mind that this is a general range, and slight variations may exist depending on the specific fuel system components and testing conditions. Always consult a reliable repair manual specific to your vehicle for the most accurate information.
Auto Repair
Wear do you check transmission fluid on the Audi allroad? Wondering How Do You Know If You Have a Broken Axle?
Car Care
Coolant Flush Why Fuel Additives Wont Improve Performance and Gas Mileage 4 Tips for Keeping Your Tires Safe Year-Round
Engine
How do you remove a distributor drive shaft on vw beetle engine? Where is the starter on a Chevy Blazer 96?
Electric Car
Cannot roll down power window on drivers side of a 2002 Buick LeSabre Custom? How do you test for short to voltage? Does a Chrysler 300M have cabin air filter?
Autopilot
10 years after DARPA Urban Challenge Team Victor Tango still works together How do you change a 2005 harley fatboy speed sensor?
Car Photos
Why does the check fuel cap message appear on a Honda 2007 Civic? What cars have 4X114.3 bolt pattern? How do you turn on the fog lights a 1994 Chrysler lhs?