1. Remove the lug nuts.
* Use a lug wrench to loosen the lug nuts on all five lug nuts on each hubcap.
* Do not remove the lug nuts completely.
2. Remove the center beauty hub cap.
* Locate two small holes on opposite sides of the hub cap center medallion.
* Insert needle-nose pliers or small screwdrivers into the holes and pry the medallion off.
* Remove the three Phillips-head screws underneath the medallion.
* Pull the center cap straight off.
3. Carefully place the hubcap face-down on a clean, flat surface.
4. Insert a plastic pry tool or flat-head screwdriver into the slots between the hubcap spokes and rim.
5. Twist the pry tool to pry up the spoke, exposing the tension ring.
6. Repeat this process for all spokes until the tension ring is completely unhooked.
7. Lift the hubcap off the rim.
8. To assemble, place the hubcap back on the rim, insert the tension ring into the spoke slots, and push down until the tension ring clips into place.
9. Repeat this process for all spokes until the tension ring is completely secure.
10. Snap on the center cap.
11. Tighten the lug nuts.
