Auto >> AutoSPT >  >> Engine

How does one jump a starter solenoid on 1966 GTO?

To jump a starter solenoid on a 1966 GTO, follow these steps:

1. Locate the starter solenoid. It is usually mounted on the firewall near the battery.

2. Disconnect the battery negative terminal. This will help to prevent any electrical shocks.

3. Find the two terminals on the starter solenoid. One terminal will be marked with a "+" sign and the other will be marked with a "-".

4. Connect a jumper cable to the positive terminal on the starter solenoid.

4. Touch the other end of the jumper cable to the positive terminal on the battery. This will send power to the starter solenoid and cause the starter motor to engage.

5. Start the engine.

6. Remove the jumper cable from the battery.

7. Reconnect the battery negative terminal.

Auto Repair
How do you replace armrest on 1992 ford van? How do you replace rear windshield wiper on 2004 Toyota Highlander?
Car Care
Is it against the law to insure a car for someone els? What are the rights of a co-signer if person who has vehicle decided not to make payments? Jaguar Land Rover urges govt. to reduce GST on luxury cars
Engine
Where abouts is the fuel pump situated? How many quarts of oil does a 5-cylinder Chevy Colorado use?
Electric Car
How many valves does the 2001 Chevrolet Camaro have? Where is the interior light control module on 2001 3500 GM van? What kind of oil do you put in 2003 Chevy Avalanche?
Autopilot
How is the rotor made to turn helicopter and in an autogyro? Four Reasons Public Agencies Take a Chance on Driverless Transportation
Car Photos
Car part that starts with the letter n? How many Buick Invicta cars were built in 1961? How do you open Volvo door?