Auto >> AutoSPT >  >> Engine

How do you remove a crankshaft pulley on 67 Chevelle?

To remove the crankshaft pulley on a 1967 Chevelle, you will need the following tools:

* A 1/2-inch drive ratchet

* A 1-inch socket

* A 3-foot breaker bar

* A large pry bar

Steps:

1. Disconnect the negative battery cable.

2. Remove the fan shroud and radiator cap.

3. Loosen the four bolts that hold the crankshaft pulley in place.

4. Insert the pry bar between the pulley and the timing cover.

5. Pry the pulley away from the timing cover.

6. Repeat steps 4 and 5 until the pulley is completely removed.

Note: If the pulley is difficult to remove, you can use a penetrating oil to loosen the bolts.

Auto Repair
How Often To Change Fuel Filter On A 6.7 Powerstroke How do you fixs your neutral safety switch on a 2007 redcat ATV?
Car Care
What is the Cadillac trademark? Where can one find affordable motorcycle insurance? Why notify dept of motor vehicles when someone dies?
Engine
How Car Rebates and Incentives Work How do you bleed the fuel system in a 2002 eclipse gs 2.4L automatic?
Electric Car
Where is the intergated power module on a 2002 dodge ram 1500? How do you remove the ignition switch from a 1988 Dodge Ram 50? Where is the transmission fluid drain plug on a 2005 Honda Pilot LX 4WD?
Autopilot
Where do you hook up the code reader for a 2001 Honda CR-V? Where can you get a frame for an 1987 El Camino?
Car Photos
At what speed do most car crashes occur at? Can your son insure his car without the title being in name? How long does a car title takes to come back in PA?