- Flywheel Puller
- Impact wrench
- 3/8 drive ratchet
- 3/8 drive extension
- 10mm socket
- 13mm socket
- 17mm socket
- 24mm socket
- Flathead screwdriver
- Small pry bar
- Gasket scraper
Instructions:
1. Remove the flywheel cover.
2. Remove the starter motor.
3. Remove the three bolts that hold the ignition coil in place.
4. Remove the ignition coil.
5. Remove the five bolts that hold the stator plate in place.
6. Remove the stator plate.
7. Use a flywheel puller to remove the flywheel.
8. Remove the Woodruff key from the crankshaft.
9. Use a flathead screwdriver and a small pry bar to pry the main bearing out of the side of the magnetic flywheel.
Note: Be careful not to damage the main bearing when removing it.
