1. Disconnect the battery: Before starting any work, disconnect the negative terminal of the battery to prevent electrical shock.
2. Locate the starter: The starter is located on the right side of the engine compartment, near the top. It is a cylindrical-shaped component with electrical connections and a solenoid attached to it.
3. Remove the electrical connections: Disconnect the electrical connections attached to the starter. There should be a main power cable and a smaller solenoid wire. Be careful not to mix up the connections when reinstalling the new starter.
4. Loosen the mounting bolts: There are two mounting bolts that hold the starter in place. Use a wrench to loosen and remove these bolts. One of the bolts are located on top of the starter and other one below
5. Remove the starter: Once the mounting bolts are removed, you can carefully remove the starter from the engine bay.
6. Install the new starter: Place the new starter in position and secure it with the mounting bolts. Tighten the bolts securely.
7. Reconnect the electrical connections: Reconnect the electrical connections that you disconnected earlier. Make sure the cables are properly connected and secured.
8. Test the starter: Reconnect the battery terminal and turn the ignition key to the "Start" position. The starter should engage and crank the engine.
Here are some additional tips for replacing the starter on a 1979 Volkswagen Beetle:
- It may be helpful to use a floor jack and jack stands to raise the front of the vehicle and provide better access to the starter.
- Make sure you have the correct replacement starter for your specific Volkswagen Beetle model.
- If you are uncomfortable performing this task yourself, it is recommended to have the starter replaced by a qualified mechanic.
