Auto >> AutoSPT >  >> Engine

How do you open bonnet when release cable becomes unattached from engine catch?

To open the bonnet when the bonnet release cable becomes unattached from the engine catch, follow the steps below.

1. Locate the bonnet release mechanism inside the vehicle, usually near the driver’s footwell.

2. Manually pull the release lever using a piece of wire, a hook, or a flathead screwdriver. This should release the bonnet.

3. Get outside the vehicle and go the front end.

4. Locate the secondary bonnet catch, usually located at the center of the bonnet.

5. Use a tool to disengage the secondary catch.

6. Lift up the bonnet to open it fully.

Note: If the bonnet is still not opening, it is recommended to seek assistance from a professional to ensure that no additional damage is caused.

Auto Repair
Why is a 2002 Honda foreman leaking gas out of the carburetor drain hole when screw tight? How do you change the head gasket in a 1988 Buick regal?
Car Care
What Are All-Terrain Tires? Do luxury cars need rust proofing? The 411 on Car Lug Nut Removers
Engine
What would cause a 1999 Chevy Cavalier 2-Door Coupe 5-speed to feel like the engine is tugging or pulling in-between shifting? Is it possible to fit a supercharger and turbocharger on the same engine?
Electric Car
Where is the theft deterrent module on a 1992 Buick LeSabre? We changed the starter battery alt voltage regulator and relay car is a 1984 mercury cougar it will run for day then wont start all you get clicking sound? Where is the fuel pump in a 1998 Cadillac STS?
Autopilot
Becoming an Autonomous Vehicle Engineer – Part 1: Beginning the Journey  How do you make a X2 pocket bike go faster at no cost?
Car Photos
Where is the fuse box located in a 2008 Mazda 3? What do the dashboard symbols stand for on a BMW 1999 z3 coupe? Where is the hood release on a Mercedes E320?