Auto >> AutoSPT >  >> Engine

What is the torque specs on a cylinder head 2010 KIA soul 2.0?

The torque specifications for the cylinder head of a 2010 KIA Soul 2.0 are as follows:

Step 1: Tighten the cylinder head bolts in the following sequence to 22 Nm (16 lb-ft):

1. Bolt No. 1

2. Bolt No. 5

3. Bolt No. 9

4. Bolt No. 10

5. Bolt No. 14

Step 2: Tighten the cylinder head bolts in the following sequence to 44 Nm (32 lb-ft):

1. Bolt No. 1

2. Bolt No. 5

3. Bolt No. 9

4. Bolt No. 10

5. Bolt No. 14

Step 3: Tighten the cylinder head bolts in the following sequence to 66 Nm (48 lb-ft) + 90 degrees:

1. Bolt No. 1

2. Bolt No. 5

3. Bolt No. 9

4. Bolt No. 10

5. Bolt No. 14

Note: Always refer to the specific repair manual for your vehicle for the most accurate and up-to-date torque specifications.

Auto Repair
On a 94 Cavalier can the inner tie rod ends be repaired or should entire assembly replaced? Can you repair a fiberglass bumper?
Car Care
Maintenance Mythbusters: AAA Top 5 Misconceptions for Auto Upkeep How many does the Passat wagon seat, and cargo space? DOT 3 vs. DOT 4 Brake Fluid Differences (Can You Mix Them?)
Engine
What is the life span of a Chevy 5.3 liter engine? How do you change the oil on a Yamaha TW200?
Electric Car
What happens if you use the same headbolts that came with your car when replacing head gasket on a Pontiac Grand Am GT? Where can one buy a used GMC dump truck? Where is the thermostat housing on a 2004 Chrysler Sebring Convertible?
Autopilot
Is there anywhere you can get a throttle positioning sensor for 1989 Honda Prelude 2.0Si other than the dealer? Day 24 Capability: Navigate lane bordered by cones
Car Photos
Hyundai Venue 2019 1.4 CRDi MT E Exterior How do you change the right front low beam headlight on a 1998 Chevy lumina? Is a 99 grand prix gt bumper cover compatible with 01 gt?