Auto >> AutoSPT >  >> Engine

How do you reset camshaft valve exhaust signal too low ECM- 616D?

To reset the camshaft valve exhaust signal too low ECM- 616D, follow these steps:

1. Turn the engine off and allow it to cool down.

2. Locate the ECM (Engine Control Module). It is usually located in the engine compartment, near the battery.

3. Disconnect the negative battery cable.

4. Wait 10 minutes for the ECM to reset.

5. Reconnect the negative battery cable.

6. Start the engine and let it run for a few minutes.

7. Check the ECM for any error codes. If there are no error codes, the ECM has been successfully reset.

If the ECM still displays the camshaft valve exhaust signal too low error code after following these steps, you may need to have the ECM replaced.

Auto Repair
How do you adjust valves on C240 Mercedes? You have an edelbrock intake and carb what other parts will be needed to hook up the throttle linkage?
Car Care
How to Check Your Engine Oil Level? Radiator Hoses More Than Half the Country Is Taking Crazy Chances On Their Bicycles
Engine
What cause Jerking and engine light on? How do you get to the battery on a 2003 Yamaha wolverine?
Electric Car
In addition to building automobiles what other innovation is Henry ford known for? What does the starter relay do in Chevy Malibu? Where is the blower resistor on a 1999 K1500 Suburban?
Autopilot
Meet a Torc Co-op: Jamie Barnes Day 6 Capability: Provide Safe Distance from Pedestrians
Car Photos
What does it mean when the dashboard warning brake light comes on in your 1995 ford mustang? Is 1991 Nissan truck compatible with 1994 pathfinder? How do you change the tail light of a Buick Rendezvous?