Auto >> AutoSPT >  >> Engine

How do you adjust the idle RPM on 87 dodge raider?

Adjusting the idle RPM on an 87 Dodge Raider

1. Start your engine and allow it to reach normal operating temperature.

2. Locate the idle speed adjustment screw. On the 87 Dodge Raider, it is located on the throttle body.

3. Turn the idle speed adjustment screw clockwise to increase the idle speed, and counterclockwise to decrease it.

4. Use a tachometer to monitor the engine's idle speed as you make adjustments.

5. The ideal idle speed for the 87 Dodge Raider is between 750 and 800 RPM.

6. Once you have set the idle speed to the desired level, tighten the lock nut on the idle speed adjustment screw to prevent it from moving.

Note:

If the idle speed is too low, the engine may stall. If the idle speed is too high, the engine may run rough and waste gas.

Auto Repair
How do you replace the headlight bulb located on a 1992 Lexus ES 300? How do you replace the ball joint of a Oldsmobile aurora 98?
Car Care
The Best SUVs for Road Trips Car Losing Water and Overheating: Causes and What To Do About It! Who buys junk cars in Orlando Florida or Used Car Buyers that pay cash on the spot for autos?
Engine
I have a 1993 Chevy pickup with 350 TBI. Every time start it whether hot or cold acts like is flooding. After minute of racing the engine clears up and runs fine. What wrong? How do you adjust the idle speed on a 98 Yamaha warrior?
Electric Car
Where is the fuel filter located on a Buick Regal? Jaguar will get its own absolutely bespoke EV platform called Panthera, CEO reveals What would cause your car to backfire lose power and stall?
Autopilot
The Infrastructure Impacts of Driverless Cars What is the minimum speed in left hand lane of interstate?
Car Photos
What were the most surprising facts about aerospace vehicle you researched? Did cars from the 1960 have radios? Where can you find a fuse box diagram for 1996 2005 Ford Mustang?