1. Safety gear, including safety glasses and gloves
2. Oil drain pan and funnel
3. Pliers
4. Flat head screwdriver
5. 3/8-inch drive ratchet and socket set
6. Oil filter wrench
7. Extension cord and light
Procedure to Remove the Oil Pump
1. Oil removal
- Ensure that the engine is cold.
- Place an oil drain pan beneath the oil pan and loosen the oil drain plug to drain the oil.
2. Prepare by Removing Components
- Remove the serpentine belt.
- Disconnect the oil cooler lines from the oil pump, if equipped.
- Remove the oil filter and clean the filter housing.
- Lift and secure the vehicle by placing it on jack stands.
- Access the oil pump from underneath the vehicle.
3. Oil Pump Removal
- Locate the oil pump.
- Remove any visible bolts or nuts holding the oil pump in place.
- Use a flat head screwdriver and pliers to pry the oil pump and gasket off the engine block. Be careful not to damage the gasket or the engine.
4. Final Inspections
- Once removed, inspect the oil pump and the oil pump cover for any damage or wear, including on the gears.
- Inspect the oil pump gasket and replace if necessary.
5. Installation
- Clean the mating surface on the engine block.
- Install a new oil pump gasket and place it on the engine block.
- Position the oil pump on the gasket.
- Reinstall the bolts or nuts that you removed earlier and tighten them
6. Connect Components
-Reconnect the oil cooler lines.
- Reinstall the oil filter.
- Replace the serpentine belt.
7. Restore Fluids and Test
- Add new oil to the engine through the oil fill tube.
- Start the engine and let it run for a few minutes.
- Check for any leaks.
Note: It's important to carefully follow these steps and ensure that the oil pump is properly installed to prevent any damage that may affect engine performance. If you are not comfortable performing this task, it's recommended to seek the assistance of a professional mechanic.
