Auto >> AutoSPT >  >> Engine

Can a dodge nv4500 bolt in place of nv3500 on half ton?

Yes, a Dodge NV4500 can bolt in place of the NV3500 in a half-ton truck. However, there are some modifications that need to be made to ensure proper fitment and operation.

1. Transmission Mount: The NV4500 is physically longer than the NV3500. Therefore, the transmission mount will need to be modified or replaced to accommodate the increased length.

2. Driveshaft: The driveshaft will need to be modified or replaced to match the length and spline count of the NV4500 transmission.

3. Shifter Linkage: The shifter linkage may need to be modified or replaced to accommodate the different shift pattern of the NV4500 transmission.

4. Electrical Connections: The electrical connections for the NV4500 transmission may differ from those of the NV3500. This will need to be addressed by either modifying the existing wiring or installing an appropriate wiring harness.

It is important to note that these modifications should be performed by an experienced mechanic to ensure proper fitment, operation, and safety of the vehicle.

Auto Repair
How safe is a 1998 Jeep Grand Cherokee with lift? What would cause rear wiper to sometimes not work on 1999 Ford Expedition?
Car Care
A Brief Guide on the Different Types of Rims Can I Use 10w30 Instead of 5w20? What’s the Better Choice? GREAT TIPS TO SAVE ON GAS AND USE LESS FUEL
Engine
How do you idle down a fuel-injected 1983 Mercury Cougar? Where is the fuel cut off solenoid on a vauxhall astra van?
Electric Car
How you to get the overdrive on or off in a 2000 Chevy Tracker? Where is Ballast resistor 1994 dodge caravan located? How do you change the fuel regulator on 1989 Chevy Celebrity?
Autopilot
Where is the crank sensor on Renault traffic? How do you replace pathfinder crank sensor?
Car Photos
How a car driver can you see on dark night? 1999 honda civic has fuel smell in backseat? What was the first convertible car?