Auto >> AutoSPT >  >> Engine

How do you remove the governor on a 93 camaro v6?

Warning: Removing the governor on a vehicle can be dangerous and is illegal in some jurisdictions. It can also void your warranty. Proceed at your own risk.

To remove the governor on a 1993 Camaro V6, you will need to follow these steps:

1. Locate the governor. It is located on the back of the transmission, near the speedometer cable.

2. Remove the bolt that holds the governor in place.

3. Remove the governor from the transmission.

4. Replace the bolt that held the governor in place.

5. Reconnect the speedometer cable.

That's it! You have now removed the governor from your 1993 Camaro V6.

Auto Repair
Palmdale Complete Auto Repair What causes a low idle in 2002 Chrysler Sebring?
Car Care
What might a friend do while driving that makes you car sick? Pros and cons of diesel engines What should you do if after a car accident your insurance company claims they did not receive payment and sent cancellation notice but it?
Engine
Where is the crankshaft position sensor in a 2003 Mitsubishi Galant? Best octane fuel for 2004 ford Crown Victoria?
Electric Car
Where is the fuel filter for a 2000 dodge caravan located? What other Fault would give you the dash light of loose gas cap in a 2007 Dodge Charger? What do the heads torque on 02 jeep liberty sport 3.7?
Autopilot
How can i get it repare or replace .Throttle actuator control throttle body range for Dodge Caliber? How do you change a crank sensor on Renault laguna 2.0 hatchback?
Car Photos
What is the turning radius of 2013 Chevrolet Camaro? How does frost form on your windshield when the temperature not reach freezing mark? What makes Ford unique?